HOME | DD
3DPad — Darksiders 2 - Death's Mask Sculpt
Published: 2013-03-04 21:48:08 +0000 UTC; Views: 2367; Favourites: 4; Downloads: 20
Redirect to original
Description
This is a comparison between my high poly model and the start of the sculpt details. Not too bad for my first actual attempt at Mudbox.Planning on spending a few hours over the next week working on this so I can print it in 3D
Related content
Comments: 2
First off amazing model. I hope you make a print of it. I do have a question. Do you start a base mesh in a 3d program or did you go straight to sculpting software?
👍: 0 ⏩: 1
Hi Seku,
Thanks for the kind comment
The mask on the left was made in 3Ds Max with a turbosmooth modifier applied.
I then imported this into Mudbox and used it to tweak the proportions and add cracks etc.
I did try to print this but..well...gravity disagreed with it so I had to call it a day.
Hope all this is of use
👍: 0 ⏩: 0